• Put in the value directly. * Recommended gap is 1.5mm (.015 inch).

・If the head gap is changed, table height is also changed.
・UJF-3042 is equipped with a function [GAP CHECK].

When ON is selected:

If an obstacle is detected before or during drawing, the table automatically moves
down away from the obstacle.
* Because the table continues to move down until the obstacle sensor does not
　react even though [Head Gap] is set to 1.5mm, the actual head gap may not be
　1.5mm. Note that movement of the head gap may cause a degraded drawing
　quality or ink mist if the obstacle sensor reacts during printing.

When OFF is selected:

If an obstacle is detected before drawing, the message “ERROR505 !WORK High” is
displayed and the operation stops.

・UJF-3042 is equipped with a function [WORK SET]
　When you check the drawing results etc., you can move the Y-bar.

[For UJF-3042HG]

If the thickness of the media is 100mm or less, it is impossible to adjust the height
of the table to 1.5mm (recommended gap). To adjust the height to the recommended
gap value, you can raise the table surface using the accompanying vacuum table and
the table spacer 50 or 100, according to the thickness of the media.

---

---

Use the following vacuum table and the table spacers, according to the thickness
of the media.

---

---

For how to set the vacuum table, see
" OPERATION MANUAL" -> "Chapter 2 Basic Operations" -> "Setting media".

---